DA Malfunction in Windows 7
Posted: Sat Mar 05, 2011 2:46 am
I downloaded and installed DA on 24 Feb 2011. I launched DA a couple of times after that and each time some of the surface isobars would only draw part way then go to the edge of the chart as several straight parallel lines bearing no relationship to the underlying data. Then, on 26 Feb 2011, Windows failed to start due to "recently installed device or application failure" and the computer went into recovery mode and went to a restore point. The computer has worked properly ever since but my downloaded copy of DA was deleted. I suspect my copy of DA was the problem.
My computer is a Dell Inspiron 15R N5010 with 4 GB of RAM and a 500 GB HD and Intel i3 processor purchased in Sept 2010. The OS is Windows 7 Home Premium. Security is provided by McAfee which I neglected to turn off during installation.
I would like to download and install another copy of DA but not if the same thing is likely to happen again.
Suggestions, anyone??
My computer is a Dell Inspiron 15R N5010 with 4 GB of RAM and a 500 GB HD and Intel i3 processor purchased in Sept 2010. The OS is Windows 7 Home Premium. Security is provided by McAfee which I neglected to turn off during installation.
I would like to download and install another copy of DA but not if the same thing is likely to happen again.
Suggestions, anyone??