The Weather Forecasting Forum
http://www.weathergraphics.com/forum/

Scheduler format?
http://www.weathergraphics.com/forum/viewtopic.php?f=5&t=1741
Page 1 of 2

Author:  garyburnett44 [ Tue Apr 24, 2012 11:29 am ]
Post subject:  Scheduler format?

Hi all
Just trying to schedule some scripts from a directory outside digital atomospheres default. Cannot work out how to format command. Have tried variations on 1955 D:\dadata\scripts\wind.dsf but to no avail. If anyone can assist it would be much appreciated
Gary

Author:  Budgie [ Tue Apr 24, 2012 8:43 pm ]
Post subject:  Re: Scheduler format?

Just setup the scheduler that's built in to DA and then use something like System Scheduler to open and close DA.
I set DA to open 2 minute before a run and then close about 10 minutes later. The 10 minutes is to allow for slow broadband speeds that occasionally occur.

Author:  garyburnett44 [ Wed Apr 25, 2012 2:27 pm ]
Post subject:  Re: Scheduler format?

Hi Budgie
Thanks for the reply. I am not sure that I expressed the question properly. What I meant was when using scheduler in DA, it only reads dsf files that are in AppData\Local\DigitalAtmosphere folder. What I was trying to do was schedule in DA a script in My Documents. I tried to specify the full path, but DA scheduler did not read the files. I have side stepped the issue but placing all my scripts in AppData\Local\DigitalAtmosphere. The question is what does DA scheduler expect as full path to file?
Not a massive porblem, but I like to work out as much as possible about the software.
regards
Gary

Author:  Budgie [ Wed Apr 25, 2012 8:33 pm ]
Post subject:  Re: Scheduler format?

I see where you're coming from now.
I've not tried that way of working as I normally just use DA's own editing & saving structure and if I need anything else then I use Notepad to work on the scripts and then copy & paste them into DA.
So I'm not much help on this one.

Author:  garyburnett44 [ Thu Apr 26, 2012 7:55 am ]
Post subject:  Re: Scheduler format?

Hi Budgie
after some time tinkering with the scheduler, I arrived at the same conclusion as you - use DA file structure as it works fine. I have got it working and got some basic charts on my site. When I have time I'll create some more.
regards
Gary

Author:  embayweather [ Fri Mar 08, 2013 4:23 pm ]
Post subject:  Re: Scheduler format?

Sorry to add to an old thread but I am having a similar problem. Each time I try to run a script, no matter where I have put it the scheduler says it cannot be found. I have been very particular about getting the exact location of the script into the scheduler as it says in the manual, but even from isdie the program it cannot be found. The script suns happily on manual.
Any advice would be welcome please.

Best wishes

Mike

Author:  embayweather [ Sat Mar 09, 2013 10:09 pm ]
Post subject:  Re: Scheduler format?

I think I have solved the problem now

Best wishes

Mike

Author:  Budgie [ Sun Mar 10, 2013 11:54 am ]
Post subject:  Re: Scheduler format?

How did you sort it, Mike, just in case someone is looking in the future? ;)

Author:  embayweather [ Sun Mar 10, 2013 4:18 pm ]
Post subject:  Re: Scheduler format?

I just put the script file into the DA program folder. It was not in a Scripts folder or anything like that, just dropped it in amongst the .exe file, map folders, .dll files etc.

Hope it helps someone, if not please get in touch and I can give you more detailed ion.

Best wishes

Mike

Author:  Budgie [ Sun Mar 10, 2013 8:44 pm ]
Post subject:  Re: Scheduler format?

Thanks Mike.

For info, my files are in C:\Users\weather\AppData\DigitalAtmosphere ("weather" being the PC name).
This is where DA put them when I installed it on the PC, but there's also a folder under C:\Program Files\DigitalAtmosphere with some program files in it as well.

Page 1 of 2 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/