I have found that the script for wind vectors which I have used for years
and is still running on a legacy edition will not work on 2.7. I am using:
analyze,vect color=0:0:0 wind (also tried 0:0:200 with no luck)
Any information on what will work?
Thanks;
Wind vector scripts
Problems with Wind Vector Command
The function: VECT COLOR=0:0:200 WIND is in the Analysis - Wind - Wind Speed Vectors.
They are to be found in the digatmos.MNU file.
Typing the line VECT COLOR=0:0:200 WIND into the Scripting page - Analysis Command results in vectors being displayed.
Therefore if using the Analysis pulldown menu, the Wind followed by Wind Speed Vectors, shows the vectors the 'fault' can only be in your script or its application and not in DA.
Therefore I am confused as to why the command is not working as it has in 2.07 and now in my ver 2.09
Regards
They are to be found in the digatmos.MNU file.
Typing the line VECT COLOR=0:0:200 WIND into the Scripting page - Analysis Command results in vectors being displayed.
Therefore if using the Analysis pulldown menu, the Wind followed by Wind Speed Vectors, shows the vectors the 'fault' can only be in your script or its application and not in DA.
Therefore I am confused as to why the command is not working as it has in 2.07 and now in my ver 2.09
Regards
Still no Joy!
Looking at the status I see the command appear, but it's as if it ignores it. Of course it plots on the pull down command. I have had this simple script operating for years on an old v1.1j3 with no problems.
I am going to pull it out of the long script where I want it and run it in several different ways and check the results.
Thanks again.
Looking at the status I see the command appear, but it's as if it ignores it. Of course it plots on the pull down command. I have had this simple script operating for years on an old v1.1j3 with no problems.
I am going to pull it out of the long script where I want it and run it in several different ways and check the results.
Thanks again.