Simple Error?
Posted: Thu Jun 23, 2005 1:14 am
Hi all,
I am currently trying to move scripts from DA 2000 to DAWS and for some reason, I can not get this script to work in DAWS to save my life. It seems to be very straight forward but I seem to still be doing something wrong.
This script is supposed to load a certain map, plot topography, then overlay the latest surface plots. When I tried this in DAWS, it does not load the map, it just stays on the map that was loaded at startup. It also does not load the topograhy. All it does is plot the surface obs, but as I said above, it can't switch maps. Below is a bit of my script. Any suggestions?
LOAD,Indonesia
TOPO
PRODUCT,plf,0
STAMP
EXPORT,c:\maps\web\indonesia.jpg
LOAD,Asia (Middle East)
TOPO
PRODUCT,plf,0
STAMP
EXPORT,c:\maps\web\mideast.jpg
LOAD,Europe (South)
TOPO
PRODUCT,plf,0
STAMP
EXPORT,C:\maps\web\med.jpg
ect.....
I am currently trying to move scripts from DA 2000 to DAWS and for some reason, I can not get this script to work in DAWS to save my life. It seems to be very straight forward but I seem to still be doing something wrong.
This script is supposed to load a certain map, plot topography, then overlay the latest surface plots. When I tried this in DAWS, it does not load the map, it just stays on the map that was loaded at startup. It also does not load the topograhy. All it does is plot the surface obs, but as I said above, it can't switch maps. Below is a bit of my script. Any suggestions?
LOAD,Indonesia
TOPO
PRODUCT,plf,0
STAMP
EXPORT,c:\maps\web\indonesia.jpg
LOAD,Asia (Middle East)
TOPO
PRODUCT,plf,0
STAMP
EXPORT,c:\maps\web\mideast.jpg
LOAD,Europe (South)
TOPO
PRODUCT,plf,0
STAMP
EXPORT,C:\maps\web\med.jpg
ect.....