Access violation

[REH_golf]

Need help to correct this after plotting data. See attachment

[carseman]

Hi,
A more detailed description of how this error occurred would be most helpful.
Chris

[REH_golf]

Thanks, Chris. It occurs when I plot the data and it recur several times as I work on the map.

Eddie

[REH_golf]

After retrieving data, I plot data on map and at the same time get the following error message: "Access violation at address 004FEFED in module 'digatmos.exe." Read of address 000003B6.

I click [OK] an proceed to draw isopleths. As soon as I do, the plotted data vanishes.

Help please!

[geophi]

What is the version of DA that you are using?

From what data source has this data been downloaded?

Does this happen for both surface and upper air data plots?

[REH_golf]

Source: metar from COD radiosonde from COD radiosonde from NIU

VERSION: 3.50a Professional

Both upper air and surface this issue occurs

[geophi]

Source: metar from COD radiosonde from COD radiosonde from NIU

VERSION: 3.50a Professional

Both upper air and surface this issue occurs

Other things that could help someone troubleshooting this:

1. When did this start occurring?

2. If it's a new problem, did you have any software or hardware changes between when it worked without a problem, and when you started getting this error?

Finally, there was a report of on these forums for a much older version with a similar problem behavior when plotting here:

viewtopic.php?p=5999&hilit=violation#p5999

A person responding to that problem report fixed it on his PC with a DA reinstall. But that didn't work for the original poster.