Page 1 of 1
Temp error
Posted: Mon Jan 29, 2007 9:09 pm
by Ian
Hi, i seam to be getting errors in temps display over the north west of scotland.
see below.
Is anybody else having the same problem
Ian
Posted: Mon Jan 29, 2007 9:48 pm
by Dave Exton
Hi Ian,
Yeahp, I've been geeting similar results. If you "quality control" the area (of this hot-spot), you'll find a bouy in that region giving very high readings. I delete the temperature on that bouy and re do the analysis.
Hope that helps!
Regards,
Dave Exton, UK.
Posted: Mon Jan 29, 2007 9:53 pm
by Ian
Cheers, found that bouy, can keep ignoring it when i run script
Posted: Tue Jan 30, 2007 3:34 am
by wxforecaster
Instead of ignoring it, you could just delete it out of the station list! Then you wouldnt have to worry about it again!
Posted: Wed Jan 31, 2007 2:32 am
by Wally Mayo
Yeah, well, I've noticed that for some problematic buoys off the US east coast, you can't delete the station off the station list. The buoys are plotted as lat/long, not off the list. One would have to find and edit out the report. You have to use a good text editor to avoid losing LINE FEEDS.