STAMP doesn't seem to work in scripts

TimWest · Post by **TimWest** » Fri Jul 23, 2004 8:26 pm

I can use STAMP from the command entry box in the scripts tab and all is fine but if I try to use it in a script, nothing happens.

Post by **Tim Vasquez** » Fri Jul 23, 2004 9:18 pm

I vaguely remember this was fixed for V1.1 but I will check anyway.

TimWest · Post by **TimWest** » Sat Jul 24, 2004 8:27 am

Well I've played about a lot more with this and it is very intermittent. Sometimes it will imprint the time stamp other times it won't. I can't seem to find any commonality as to when it works and when it doesn't though!

TimWest · Post by **TimWest** » Sat Jul 24, 2004 9:05 am

Okay, I have a workaround. If you enter stamp followed by stamp it works every time!

Post by **Tim Vasquez** » Sat Jul 24, 2004 3:29 pm

What version?

TimWest · Post by **TimWest** » Sat Jul 24, 2004 4:17 pm

V1.1a

Post by **Tim Vasquez** » Sat Jul 24, 2004 4:34 pm

I don't see any obvious cause. I will add some code in to at least make sure the map is refreshed afterward.

TimWest · Post by **TimWest** » Sat Jul 24, 2004 4:35 pm

Okay, at least the double stamp fixes it if all else fails.

Wally Mayo · Post by **Wally Mayo** » Sat Jul 24, 2004 9:39 pm

Yep. Confirmed. Stamp in scripts is now intermittant since I went from 1.0q to 1.1b

Will use workaround until fixed.

Post by **Tim Vasquez** » Sun Jul 25, 2004 5:19 am

OK, looks like another bug to investigate further.