Page 1 of 1
Information about aspect and offset
Posted: Mon Jul 26, 2004 9:05 pm
by Weasel
is no longer available when you load a saved basemap, and then go to generate basemap. This figures where available in 1.1b....I wish I would have written them down before downloading c !!!!!!
Posted: Mon Jul 26, 2004 10:33 pm
by Tim Vasquez
Very little has changed since V1.1a... certainly nothing to do with mapping.
Tim
Posted: Mon Jul 26, 2004 10:50 pm
by Weasel
That was my mistake. I don't think DA ever did display this after a saved base map was loaded, it always defaults to 0 and 1. It would be nice if this infrmation was saved though.
What happened was when I was working with these yesterday, after I created and saved a map, I went ahead and loaded a previously saved map and then looked at generate base map. As these numbers change little from map to map, I thought these were the figures for the map I had just loaded, Instead they were for the map I had created prior to loading the one being displayed.