Page 1 of 1
MM5 pressure question
Posted: Fri Mar 03, 2006 8:58 pm
by Brian S
Hi,
Does anyone know the default (suggested) top layer pressure (pt) for MM5?
Thanks
Posted: Sat Mar 04, 2006 8:59 pm
by Brian S
The top model level atmospheric pressure in MM5 should be a constant.
I think this would be the pressure corresponding to sigma pressure level 0.
Does anyone actually know what this pressure (in mb) typically would be in MM5?
Posted: Tue Mar 14, 2006 7:20 am
by mlewis73
Brian S wrote:The top model level atmospheric pressure in MM5 should be a constant.
I think this would be the pressure corresponding to sigma pressure level 0.
Does anyone actually know what this pressure (in mb) typically would be in MM5?
Try 50mb. Just a guess based on personal experience while writing my thesis...
Mike
Posted: Wed Jul 30, 2008 3:40 pm
by asnorjps
Does anyone can help me on RIP command in MM5 application. Please.
Posted: Wed Jul 30, 2008 4:10 pm
by asnorjps
RIP or MM5toGrADS in MM5 application:
Do you can help me on this seriously and 200% need help. If you could help me please guide me via yahoo mesengger and my ID is
klmale2005@yahoo.co.uk. MAY GOD BLESS YOU.